Click the button on the Linear Takeoff Tools toolbar,
Click on a point in a corner of the oval or circle you need to draw (that lines up vertically and horizontally with the edges of the object),
While holding down the mouse button, drag diagonally away from the first point to draw your ellipse,
Release the mouse button when the ellipse is correct - do not worry if it is not exact, you can go back and adjust it as needed
Once drawn, there are four control boxes, at each corner of the box that encompasses the ellipse, which allow you to resize/reshape the oval.
Notes about Elliptical Linear Objects
Drop/Run setting is ignored in elliptical linear objects as there is no begging nor end to the object
Slope setting is ignored in elliptical linear objects
Length Results are calculated based on the width of the Takeoff Item - the length is calculate along the middle of the linear... (the higher the Width setting in Takeoff Item Properties, the longer the calculated length)
Warning
Before drawing any takeoff, you must set and verify Scale, see Related Articles.
The information in this site is protected by copyright by ConstructConnect. You may not reproduce, adapt, or publish any content from this site in whole or in part for any purpose, without the express written consent of ConstructConnect, Inc.Copyright 2024 - All Rights Reserved.