ConstructConnect Home | CONTACT | SALES: 1-800-364-2059
 
Getting Started with ConstructConnect Takeoff


Tools
Categories

17.04 Settings - Snap Angle

Last Updated: 2022-02-15 08:59

Default settings are user preferences that affect how you work with the program and some settings that get applied to new Bids.

Snap Angle Settings

Snap Angle

By default, when you draw takeoff, the program 'snaps' lines and segments in 15° increments. This usually makes it easier to draw takeoff that matches Architectural plans. Sometimes, however, you need to override this "Snap Angle" and draw a line or segment at something other than 15, 30, 45, or 90 degrees.

  • Disabling Per-Use
    • You can override the snap angle as you draw takeoff by holding down the <SHIFT> key. This allows you to draw a line or a segment at any angle you want. When you release the <SHIFT> key, the Snap Angle will be turned back on.
  • Disabling Always
    • If you want the program to allow you to draw lines and segments at any angle by default, change the "Default Snap Angle" value to "0". This disables the Snap Angle entirely.
  • Enabling Per-Use
    • If you've set "Default Snap Angle" to "0", it is a good idea to set "Shift Key Snap Angle" to "15" - this way, if you need the program to snap a line or segment, you can invoke 'Snap Angle' by pressing <SHIFT>.

click here to view the previous article Settings - Preferences Settings - Crosshairs click here to view the next article



 

The information in this site is protected by copyright by ConstructConnect. You may not reproduce, adapt, or publish any content from this site in whole or in part for any purpose, without the express written consent of ConstructConnect, Inc.
Copyright 2024 - All Rights Reserved.