ConstructConnect Home | CONTACT | SALES: 1-800-364-2059
 
Getting Started with ConstructConnect Takeoff


Tools
Categories

07.04.04 Drawing Two Segments at Right Angles

Last Updated: 2022-02-21 13:49

To draw two connected segments at right angles to each other, use the Right Angle Segments (aka "Two click - Two Line" two line-two segment button) tool and accomplish this in, literally, two clicks.

To draw two, right-angle connected segments,

  • Click the Two line-Two segment tool button on the toolbar,
  • Click on the end point of the first segment (not the point that connects the two segment, one of the endpoints),
  • Then, click on the endpoint for the second segment (again, not the point that connects the two segments, the program figures that out automatically).

Examples

Depending on where you start and the direction of the second point relative to the first, the lines are drawn above or below the two points.

Starting above and to the right or left of the endpoint draws the segments below the line.

starting in upper-right draws the segments below the line
Upper-right to lower-left

starting in upper-left draws the segments below the line
Upper-left to lower-right

Starting below and to the right or left of the endpoint draws the segments above the line.

starting in lower-right draws the segments above the line
Lower-right to upper-left

starting in lower-left draws the segments above the line
Lower-left to upper-right

Once drawn, the segments can be selected and manipulated independently - they are not connected.

Warning
Before drawing any takeoff, you must set and verify Scale, see Related Articles.

click here to view the previous article Drawing Arcs as You Draw Continuous Mode Linear Takeoff Rectangle Linear Takeoff Tool click here to view the next article



 

The information in this site is protected by copyright by ConstructConnect. You may not reproduce, adapt, or publish any content from this site in whole or in part for any purpose, without the express written consent of ConstructConnect, Inc.
Copyright 2024 - All Rights Reserved.